Periphery module MIO84 (8 digital- and 4 analog in- or outputs)
€245,03
Quickly available!
The periphery module PM-MIO84 is a compact module with mixed digital and analog inputs or outputs and counter function. It is designed for all those, who have to control. only a few digital and analog signals and maybe something to count. The I/O-configuration is done by ConfigStage- software, where the integration time is assigned (expands resolution from 12…16Bit).
Single digital inputs for 24V, relay outputs for 230V as single potential free contacts or configurable digital in-/output modules for 24V ? each of the <20mm smart periphery units contains state-LEDs, a 45? angled and space-saving connect area and can be labeled wit customized logos. INSEVIS stands for permanent innovation, even at the digital signals layer too: As example the backreadable digital outputs can be configured ba software, if the output or input shall be used. So this DIO16-module can be used as a spare module for some I/Os to spend it during commissioning the application.
- insertion stripe with description field for every signal
- cage-clamp connector with 2 lift arms or bolt flanges on side
| DIGITAL inputs or outputs | ||
| Load voltage L+ | 24V DC (10 V ... 30 V DC) | |
| Digital in-/outputs | 8 in- or outputs | |
| Diagnostic LEDS | 8, green | |
| Cumulated current | 2 A (max. to 60°C) | |
| Output current for signal 0 | 0,5 mA (max.) | |
| Output current for signal 1 | 0,5 A (max. to 60º C | |
| Counter | 2 each as forward counter, forward/backward counter or incremental encoder | |
| Frequency limit | 10 kHz | |
| Broken wire detection | no | |
| Error diagnostic | no | |
| Potential seperation to PLC | no | |
| Outputs: switch on delay | 50 μs (typ.) | |
| Outputs: switch off delay | 30 μs (typ., without load) | |
| Switch on/off delay | 25 μs | |
| Max. switching frequency of outputs | 100 Hz with ohmic load | |
| ANALOG inputs or outputs | ||
| Load voltage L+ | 24V DC (17 V ... 30 V DC) connected by device suppl. | |
| Analog inputs | 4 (alternatively to outputs, what is SW-configurable) | |
| Input areas | ±20 mA, 4...20 mA, 0..10 V | |
| Diagnostic LEDs (no displaying broken wires and open inputs) | 4, green: signal in valid area and 4, red: override or saturation | |
| Precision (typ.) | < 1% | |
| Analog outputs | 4 (alternatively to intputs, what is SW-configurable) | |
| Output areas | 0...20mA,4...20mA, ±10V | |
| Diagnostic LEDs | 4, green in valid area and 4, red override or load error | |
| Setting time /response time | t =1,5 ms (typ) | |
| Load resistance against A-GND | mA: 500 Ω (max.) and V: 1 kΩ (min.) | |
| Resolution | 12...16Bit (depending on integration time assigned in ConfigStage) | |
| Deviation (based on input area) | < 1% |
Description |
Order number |
| Periphery module MIO84 | PM-MIO84-02 |
| Connector 2x10pin with lift arms | E-CON20D-00 |
| Connector 2x10pin with bolt flanges | E-CONS20D-00 |
