Periphery module 16 digital inputs 24V

Periphery module 16 digital inputs 24V

The periphery module PM-DI16 is a compact periphery module for 16 digital inputs 24V

Single digital inputs for 24V, relay outputs for 230V as single potential free contacts or configurable digital in-/output modules for 24V – each of the <20mm smart periphery units contains state-LEDs, a 45° angled and space-saving connect area and can be labeled wit customized logos. INSEVIS stands for permanent innovation, even at the digital signals layer too: As example the backreadable digital outputs can be configured ba software, if the output or input shall be used. So this DIO16-module can be used as a spare module for some I/Os to spend it during commissioning the application.

  • insertion stripe with description field for every signal
  • cage-clamp connector with 2 lift arms or bolt flanges on side
Sensor supplyshort circuit proof output, current limited to 30 mA (typ.)
Load voltageL+ 24V DC (11V ... 30V DC, is connected by device supply)
Digital inputs16
Diagnostic LEDs 16 green
Input voltage for signal 00V ... +5 V
For signal 1+7,5V ... +30 V
Input current for signal 11 mA
Broken wire detectionno
Potential separation to PLCno
Access of 2-wire-BEROno
Input delay90 μs (typ.)
Output delay1,4 ms (typ.)
Sampling cycle timeas onboard modul on the PLC = cycle synchronous



Periphery module 16 digital inputs 24VPM-DI16-02
Connector 2x10pin with pin markings and lift arms on side (for DI/DIO/MIO)E-CON20D-00
Connector 2x10pin with pin markings and bolt flanges on side (for DI/DIO/MIO)E-CONS20D-00
vraag meer informatie over toepassingen aan via ons contactformulier.