DP/CAN Coupler CANopen

On the PROFIBUS-DP, the DP/CAN coupler is a normal participant.
The I/O data of the CANopen? participants is shown in the PROFIBUS in a transparent and freely configurable manner.
The DP/CAN coupler is integrated in the hardware configurator with a GSD file and can be completely configured there. Additional tools are not necessary.

On PROFIBUS, all standard transfer rates up to 12 Mbps are supported; on the CAN bus up to 1 Mbps.
The PROFIBUS address is set using a DIP switch.
Parameterization of the CANopen participants using SDO frames and administration of emergency messages is also possible.
Alternatively, the DP/CAN coupler can also be used as a CAN Layer 2 device on the CAN bus. This makes it possible to also integrate customer-specific CAN protocols via PROFIBUS.

Up to 1 Mbps CAN transfer rate
Up to 12 Mbps PROFIBUS-DP
Address setting using DIP switches
Easy configuration via GSD file
No handling blocks or parameterization software necessary
3 status LEDs
Extended ambient temperature
USB port for firmware updates
Up to 15 CANopen participants
CANopen master and CAN Layer 2 possible

Vraag direct een offerte aan!

DP/CAN Coupler CANopen

Neem contact op voor de actuele levertijden.

Meer informatie aanvragen

PROFIBUS interface
	Protocol	PROFIBUS-DP
	Transmission rate	max. 12 Mbps, autom. detection
	I/O image size	max. 240 bytes of input / 240 bytes of output data
	Connection	SUB-D female connector, 9-pin
CAN interface
	Type	ISO/DIN 11898-2 CAN High-speed physical layer
	Transmission rate	10 kbps ... 1 Mbps
	Protocol	CANopen® master CAN 2.0A (11 bit)
	Connection	Terminal 3-pin
	TPDOs	4
	RPDOs	4
	Features	Sync timer
Status indicator	3 LEDs
Voltage supply	24 V DC, 18–30 V DC
Current draw	typ. 180 mA with DC 24 V